Siemens SIMOVERT MASTERDRIVES Manual page 108

01.2006
5.4.3.9 Issuing commands via the OP1S
Key
ON/OFF1
O
Motorized potentiometer: setpoint
higher, lower (only effective within
the operating display)
Setpoint specification by means
0 9
of fixed setpoint (only effective
to
within the operating display. If
entered with numerical key,
confirm with "P")
or
Reversing
Acknowledging (only effective
Reset
within the operating display)
Jogging with jog setpoint 1 (only
Jog
effective in the "Ready" status)
NOTE
Siemens AG 6SE7087-6QX70 (Version AF)
SIMOVERT MASTERDRIVES
Control functions and setpoint specifications for the connected unit can
be selected with the corresponding keys of the OP1S, for example
during start-up. To do so, the sources of the control commands have to
be added to the corresponding bits of word 1 of the SCom1 interface.
For setpoint specification, the sources of the setpoints must be
appropriately "interconnected". In addition, the setpoint to be changed
is to be parameterized as a displayed value in the 3rd line of the
operating display.
Function
The OFF function can also be performed with OFF2 or OFF3 instead of
OFF1. For this, the source of OFF2 (P555) or OFF3 (P556) must be
"interconnected" to 2101 or 2102 respectively in addition to setting
P554.
Compendium Motion Control
Parameter number
P554
Source ON/OFF1
P573
Source Raise MOP
P574
Source Lower MOP
P443
Source Main Setpoint
P049.004
Setpoint Operating Disp
P443
Source Main Setpoint
P573
Source Raise MOP
P574
Source Lower MOP
P049.004
Setpoint Operating Disp
P571
Source clockwise direc.
of rotation
P572
Source anti-clockwise
direc. of. rotation
P565
Source Acknowledge
P568
Source Jog Bit 0
P448
Jog Setpoint 1
Parameterization
Parameter value
2100
2113
2114
KK0058
(MOP Output)
424
(MOP Out)
KK0040
(Fixed setpoints)
0
0
e.g. 401
(selected fixed setpoint)
2111
2112
2107
2108
Setpoint in %
5-29