Siemens SIMOVERT MASTERDRIVES Manual page 362

05.2006
8.2.8.1 Operating the CBP with a SIMATIC S5
COM ET200 up to
Version V4.x
Example
Siemens AG 6SE7087-6QX70 (Version AG)
SIMOVERT MASTERDRIVES
When the CBP is used with a SIMATIC S5, it is operated as a standard
DP slave.
As possible master boards, the IM308 B or the IM308 C can be used, or
even the CP5431 in limited form.
The planning tools COM ET200 or COM PROFIBUS are available for
configuring the master station.
If older versions of these planning tools are used, you must copy the
master file or type-description file from the accompanying floppy disk into
the appropriate sub-directory of the planning software.
When configuring the CBP, please use the SI8045TD.200 type-
description file on the floppy disk.
Please copy the type-description file into the directory containing the
COM ET 200 files in the PG/PC.
CD C:\COMET200
COPY A:\SI8045TD.200 C:
The type of PPO is selected in the configuration mask of COM ET200 up
to Version V4.x by entering identification bytes in accordance with the
above table of identification bytes.
Compendium Motion Control
Communication / PROFIBUS
8.2-75