Hitachi H8/3062 Hardware Manual page 592

Bit 2—Program-Verify Mode (PV): Selects program-verify mode transition or clearing. (Do not
set the SWE, ESU, PSU, EV, E, or P bit at the same time.)
Bit 2
PV Description
0 Program-verify mode cleared
1 Transition to program-verify mode
[Setting condition]
When FWE = 1 and SWE = 1
Bit 1—Erase Mode (E): Selects erase mode transition or clearing. (Do not set the SWE, ESU,
PSU, EV, PV, or P bit at the same time.)
Bit 1
E Description
0 Erase mode cleared
1 Transition to erase mode
[Setting condition]
When FWE = 1, SWE = 1, and ESU = 1
Note: Do not access the flash memory while the E bit is set.
Bit 0—Program (P): Selects program mode transition or clearing. (Do not set the SWE, ESU,
PSU, EV, PV, or E bit at the same time.)
Bit 0
P Description
0 Program mode cleared
1 Transition to program mode
[Setting condition]
When FWE = 1, SWE = 1, and PSU = 1
Note: Do not access the flash memory while the P bit is set.
576
(Initial value)
(Initial value)
(Initial value)