Table of Contents
Advertisement
On-Chip RAM Area Divisions in Boot Mode: In boot mode, the RAM area is divided into an
area used by the boot program and an area to which the user program is transferred via the SCI, as
shown in figure 18.7. The boot program area becomes available when a transition is made to the
execution state for the user program transferred to RAM.
Note: The boot program area cannot be used until a transition is made to the execution state
for the user program transferred to RAM. Note also that the boot program remains in
this area in RAM even after control branches to the user program.
Notes on Use of Boot Mode:
1. When the H8/3064F-ZTAT chip comes out of reset in boot mode, it measures the low period
of the input at the SCI's RxD
it takes about 100 states for the chip to get ready to measure the low period of the RxD
2. In boot mode, if any data has been programmed into the flash memory (if all data is not 1), all
flash memory blocks are erased. Boot mode is for use when user program mode is unavailable,
such as the first time on-board programming is performed, or if the program activated in user
program mode is accidentally erased.
3. Interrupts cannot be used while the flash memory is being programmed or erased.
4. The RxD
and TxD
1
5. Before branching to the user program the H8/3064F-ZTAT terminates transmit and receive
operations by the on-chip SCI (channel 1) (by clearing the RE and TE bits to 0 in the serial
control register (SCR)), but the adjusted bit rate value remains set in the bit rate register
(BRR). The transmit data output pin, TxD
P9DDR, P9
DR = 1 in P9DR).
1
H'FFDF20
H'FFE71F
H'FFE720
H'FFFF1F
Figure 18.7 RAM Areas in Boot Mode
pin. The reset should end with RxD
1
lines should be pulled up on the board.
1
Boot program
area
User program
transfer area
, goes to the high-level output state (P9
1
high. After the reset ends,
1
DDR = 1 in
1
input.
1
541
Advertisement
Table of Contents
