Flash Memory Programming/Erasing - Hitachi H8/3062 Hardware Manual

Single-chip microcomputer
Hide thumbs Also See for H8/3062:
Table of Contents

Advertisement

19.6

Flash Memory Programming/Erasing

A software method, using the CPU, is employed to program and erase flash memory in the on-
board programming modes. There are four flash memory operating modes: program mode, erase
mode, program-verify mode, and erase-verify mode. Transitions to these modes for addresses
H'000000 to H'01FFFF are made by setting the PSU, ESU, P, E, PV, and EV bits in FLMCR1.
The flash memory cannot be read while being programmed or erased. Therefore, the program
(user program) that controls flash memory programming/erasing should be located and executed in
on-chip RAM or external memory.
See section 19.11, Flash Memory Programming and Erasing Precautions, for points to be noted
when programming or erasing the flash memory. In the following operation descriptions, wait
times after setting or clearing individual bits in FLMCR1 are given as parameters; for details of
the wait times, see section 22.4.6, Flash Memory Characteristics.
Notes: 1. Operation is not guaranteed if setting/resetting of the SWE, ESU, PSU, EV, PV, E, and
P bits in FLMCR1 is executed by a program in flash memory.
2. When programming or erasing, set FWE to 1 (programming/erasing will not be
executed if FWE = 0).
3. Programming must be executed in the erased state. Do not perform additional
programming on addresses that have already been programmed.
595

Advertisement

Table of Contents
loading

Table of Contents