Table of Contents
Advertisement
Following the elapse of (x) µs or more after the SWE bit is set to 1 in FLMCR, 32-byte data is
written consecutively to the write addresses. The lower 8 bits of the first address written to must
be H'00, H'20, H'40, H'60, H'80, H'A0, H'C0, or H'E0. Thirty-two consecutive byte data transfers
are performed. The program address and program data are latched in the flash memory. A 32-byte
data transfer must be performed even if writing fewer than 32 bytes; in this case, H'FF data must
be written to the extra addresses.
Next, the watchdog timer (WDT) is set to prevent overprogramming due to program runaway, etc.
Set a value greater than (y + z + α + ß) µs as the WDT overflow period. Preparation for entering
program mode (program setup) is performed next by setting the PSU bit in FLMCR. The
operating mode is then switched to program mode by setting the P bit in FLMCR after the elapse
of at least (y) µs. The time during which the P bit is set is the flash memory programming time.
Make a program setting so that the time for one programming operation is within the range of (z)
µs.
The wait time after P bit setting must be changed according to the number of reprogramming
loops. For details, see section 22.2.6, Flash Memory Characteristics.
17.5.2
Program-Verify Mode
In program-verify mode, the data written in program mode is read to check whether it has been
correctly written in the flash memory.
Clear the P bit in FLMCR, then wait for at least ( α ) µs before clearing the PSU bit to exit
program mode. After exiting program mode, the watchdog timer setting is also cleared. The
operating mode is then switched to program-verify mode by setting the PV bit in FLMCR. Before
reading in program-verify mode, a dummy write of H'FF data should be made to the addresses to
be read. The dummy write should be executed after the elapse of (γ ) µs or more. When the flash
memory is read in this state (verify data is read in 16-bit units), the data at the latched address is
read. Wait at least (ε) µs after the dummy write before performing this read operation. Next, the
originally written data is compared with the verify data, and reprogram data is computed (see
figure 17.11) and transferred to RAM. After verification of 32 bytes of data has been completed,
exit program-verify mode, wait for at least (η) µs, then determine whether 32-byte programming
has finished. If reprogramming is necessary, set program mode again, and repeat the
program/program-verify sequence as before. The maximum number of repetitions of the
program/program-verify sequence is indicated by the maximum number of programming
operations (N).
Note: A 32-byte area to store program data and a 32-byte area to store reprogram data are
required in RAM.
498
Advertisement
Table of Contents
