Hitachi H8/3062 Hardware Manual page 548

Single-chip microcomputer

Hide thumbs Also See for H8/3062:

Table of Contents

Overview of Operation

Mode Transitions

When the mode pins and the FWE pin are set in the reset state and a reset-start is executed, the

H8/3064F-ZTAT enters one of the operating modes shown in figure 18.2. In user mode, flash

memory can be read but not programmed or erased.

Flash memory can be programmed and erased in boot mode, user program mode, and PROM

Boot mode and user program mode cannot be used in the H8/3064F-ZTAT's mode 6 (normal

mode with on-chip ROM enabled).