Water Hose Removal And Installation; Radiator Reservoir Tank Inspection - Suzuki VLR1800 Service Manual

4) Any leakage from the connecting section should be
corrected by proper tightening. Refer to "Water Hose
Routing Diagram (Page 1F-3)".
5) After finishing the water hose inspection, reinstall the
removed parts.

Water Hose Removal and Installation

Removal
1) Drain engine coolant. Refer to "Cooling System
Inspection in Section 0B (Page 0B-15)".
2) Remove the fuel tank. Refer to "Fuel Tank Removal
and Installation in Section 1G (Page 1G-8)".
3) Remove the water hose as shown in the water hose
routing diagram. Refer to "Water Hose Routing
Diagram (Page 1F-3)".
Installation
1) Install the water hose as shown in the water hose
routing diagram. Refer to "Water Hose Routing
Diagram (Page 1F-3)".
I822H1160010-01
2) Pour engine coolant and bleed air from the cooling
circuit. Refer to "Cooling System Inspection in
Section 0B (Page 0B-15)".
3) Reinstall the fuel tank. Refer to "Fuel Tank Removal
and Installation in Section 1G (Page 1G-8)".

Radiator Reservoir Tank Inspection

Inspect the radiator reservoir tank in the following
procedures:
1) Remove the left frame lower cover and secondary
gear case cover. Refer to "Exterior Parts Removal
I822H1160011-01
and Installation in Section 9D (Page 9D-3)".
2) Inspect the radiator reservoir tank cooling leaks. If
any defects are found, replace the radiator reservoir
tank with a new one.
I822H1160012-01
I822H1160013-01
Engine Cooling System:
B822H11606006
B822H11606007
I822H1160014-01
1F-7