Repair Instructions; Heated Oxygen Sensor (Ho2S) Removal And Installation; Heated Oxygen Sensor (Ho2S) Inspection; Pair Reed Valve Removal And Installation - Suzuki GSX1300R Manual

1B-9 Emission Control Devices:
Heated Oxygen Sensor (HO2S) Removal and
Installation
Removal
WARNING
!
Do not remove the HO2 sensor while it is hot.
CAUTION
!
• Be careful not to expose the HO2 sensor to
excessive shock.
• Do not use an impact wrench when
removing or installing the HO2 sensor.
• Be careful not to twist or damage the
sensor lead wires.
1) Remove the right side cowling. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-14)".
2) Disconnect the HO2 sensor coupler (1).
3) Remove the HO2 sensor (2).

Repair Instructions

B815H21206001
1
2
I815H1120008-01
Installation
Install the HO2 sensor in the reverse order of removal.
Pay attention to the following points:
CAUTION
!
Do not apply oil or other materials to the
sensor air hole.
• Tighten the HO2 sensor (1) to the specified torque.
Tightening torque
HO2 sensor (a): 25 N·m (2.5 kgf-m, 18.0 lb-ft)

Heated Oxygen Sensor (HO2S) Inspection

Refer to "DTC "C44" (P0130/P0135): HO2 Sensor
(HO2S) Circuit Malfunction in Section 1A (Page 1A-
102)".

PAIR Reed Valve Removal and Installation

Removal
1) Lift and support the fuel tank. Refer to "Fuel Tank
Removal and Installation in Section 1G (Page 1G-
9)".
2) Remove the air cleaner box. Refer to "Air Cleaner
Box Removal and Installation in Section 1D
(Page 1D-6)".
3) Disconnect the PAIR hoses (1) and remove the PAIR
reed valve covers (2).
1
1
(a)
I815H1120009-01
B815H21206002
B815H21206003
2
I815H1120010-01