Intercom Call Voice/Tone Signal Selection - NEC Xen IPK Programming Manual

Xen IPK
Intercom Call Voice/Tone
Signal Selection
General Description
Use this Memory Block to determine whether signal tone or voice is used first for an
intercom call.
Display
Data Setting
No. Data
0 1 : T O N E
T I M E
Settings
LK 1 LK 2
Tone Voice
LK 5 LK 6
Programming Procedures
1 Go off-line.
2 Press LK1 + LK2 + KA
3 Press the corresponding CO/PBX line key to change the data option.
N
4 Press to write the data.
P
Press to go back on-line.
5
Related Programming
M.B. Number
1-6-03 DSS Call Voice/Tone Signal Selection
N
1. Switch from voice to tone signalling or from tone to voice by dialling a station number, then dialling 1.
2. If tone signalling is programmed in this Memory Block, the called party cannot answer handsfree unless the originator
of the call dials 1.
3. This Memory Block has no effect on incoming Voice Announcement Tie/DID line calls. Refer to Memory Block , 1-1-34
, Tie Line First Ring Pattern Selection.

1-2-01, Intercom Call Voice/Tone Signal Selection

Title
C A L L
D I S P L A Y
LK 3 LK 4
The shaded area indicates
the default setting.
LK 7 LK 8
to access the Memory Block.
Memory Block Name
Programming Manual
1-2-01
System Mode
1
Submode
2
Data No.
01
PC Programming
+BI
DRAFT 3
Chapter 1 – 129