Trunk Group Outgoing Priority Selection - NEC Xen IPK Programming Manual

Xen IPK
Trunk Group Outgoing
Priority Selection
General Description
Use this Memory Block to assign the Outgoing Priority for trunk access to each Trunk
Group. This is normally used with a Tie Line or K-CCIS network to reverse the search order
and reduce call collisions during trunk seizure
Applicable for IPK R2000 and above.
Display
Trunk Group No. Data
(01~32) No.
0 1 / 0 6 : P R I O R .
T I M E
Settings
LK1 LK2
H → L L → H
High to Low Low to High
Programming Procedures
1 Go off-line.
N
2 Press LK5 + + KF
3 Press the corresponding CO/PBX line key to change the Setting Data option.
N
4 Press to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
Related Programming
M.B. Number
1-1-46~48 Access Code (1-, 2- or 3-Digit) Assignment
Function 201~232 – Route Advance Block 01~32
Function 401~416 – Closed Number Block 01~32
Function 601~604 – ACR Table 1~4
1-1-30 Route Advance Block Assignment
1-1-49 Networking Trunk Group/Route Advance Assignment
1-14-04 ACR Trunk Group to Route Number Assignment
N
This Memory Block should not be assigned (use default) for trunk groups with trunks belonging to an IAD(8)-
U( ) ETU used with IP (K-CCIS) or IP (K-CCIS) to NEAX (Point-to-Multipoint).

5-06, Trunk Group Outgoing Priority Selection

.
Setting
Title Data
H > L
D I S P L A Y
LK3 LK4 LK5
2 3 4
to access the Memory Block.
P
to go back on-line.
LK6 LK7
Memory Block Name
Programming Manual
System Mode
5
Submode
—
Data No.
06
PC Programming
+ ALN
LK8
The shaded area indicates
the default setting.
DRAFT 3
Chapter 1 – 491
5-06