Automated Attendant Extension Number Assignment - NEC Xen IPK Programming Manual

December 2004
Automated Attendant
Extension Number
Assignment
General Description
Use this Memory Block to assign the extension number of each AA message.
Display
Data
No. Title
2 1 : A A M S G 1
T I M E
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 + BA
3 Use the dial pad to enter data.
Note: Use the following to enter data:
A ~ H to enter Automated Attendant message number
2-Digit Station Number: 10~99
3-Digit Station Number: 100~999
4-Digit Station Number: 1000~9999
U
to clear all data when cursor is at setting position (Depends what length the
N
4 Press to write the data, and advance to the next A.A.No.
5 After the last entry, press
P
6 Press to go back on-line.
Related Programming
M.B. Number
Refer to
N
1. Extension number cannot be the same as the physical extension, CAR, ACD/UCD/SCD pilot number.
DRAFT 3
188 – Chapter 1
A.A. Msg.
No.
Setting
1~8
Data
=
D I S P L A Y
to access the Memory Block.
extension number has been assigned in MB1-2-03.)
N
to write the data.
Chapter 2, Guide to Feature Programming.
Memory Block Name

Automated Attendant Extension Number Assignment, 1-4-21

NEC Business Solutions Ltd
System Mode
1
Submode
4
Data No.
21
PC Programming
+ AU
Default Values
Not assigned.
1-4-21