Slt Hookflash Signal Selection - NEC Xen IPK Programming Manual

December 2004
SLT Hookflash Signal
Selection
General Description
Use this Memory Block to specify whether a line is held internally, or if behind a PBX, a hookflash
(HF) signal is sent to the line when a Single Line Telephone user performs a hookflash.
Display
Data
No.
0 2 : S I G N A L
T I M E
Settings
LK 1 LK 2
Hold Flash
LK 5 LK 6
Programming Procedures
1 Go off-line.
Press LK1 + LK3 +
2 KB
3 Press the corresponding CO/PBX line key to change the data option.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
1-1-02 Hookflash Time Selection
4-24 SLT Hookflash Assignment
N
1. If Hold is specified, the CO/PBX line is put on Exclusive Hold.
2. If Hold is selected, the PBX/CTX line can receive the hookflash signal via Access Code 6# (default).
3. If Flash is specified, press the hookswitch to send the hookflash signal to the PBX/CTX line.
DRAFT 3
154 – Chapter 1
Setting
Title
Data
H 0 L D
D I S P L A Y
LK 3 LK 4
The shaded area indicates
the default setting.
LK 7 LK 8
to access the Memory Block.
Memory Block Name

SLT Hookflash Signal Selection, 1-3-02

NEC Business Solutions Ltd
1-3-02
System Mode
1
Submode
3
Data No.
02
PC Programming
+ BTI