Trunk Incoming Answer Mode Selection - NEC Xen IPK Programming Manual

Xen IPK
Trunk Incoming Answer
Mode Selection
General Description
This Memory Block specifies, per outside line, the incoming answer mode (Automatic Trunk-to-
Trunk Transfer, Automated Attendant, or DISA).
Display
CO/PBX
No.
Data
(01~64)
No.
0 1 / 0 5 : N O
T I M E
Settings
LK 1 LK 2
Automatic
Automated
Trunk-to-
Normal Attendant/
Trunk
Transfer
LK 5 LK 6
Programming Procedures
1 Go off-line.
N
2 Press LK3 + +
3 Press the corresponding CO/PBX line key to change the data option.
Line Key
LK 1
LK 2
LK 3
Note: Use the following to enter data:
R
to go to the next CO/PBX Port No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
Refer to Chapter 2, Guide to Feature Programming.

3-05, Trunk Incoming Answer Mode Selection

Setting
Data
A S S I G N
D I S P L A Y
LK 3 LK 4
The shaded area indicates
DISA
the default setting.
LK 7 LK 8
KE to access the Memory Block.
LCD Indication
when Selected
NO ASSIGN
TANDM TRF Automatic Trunk-to-Trunk Transfer
AA
Definition
Normal
Automated Attendant/DISA
Memory Block Name
Programming Manual
System Mode
3
Submode
—
Data No.
05
PC Programming
+ BCT
DRAFT 3
Chapter 1 – 343
3-05