Disa/Id Code Assignment - NEC Xen IPK Programming Manual

Xen IPK

DISA/ID Code Assignment

General Description
This Memory Block specifies the Direct Inward System Access (DISA) ID Code numbers.
Display
ID Buffer No.
Data
(01~C0)
No.
0 1 / 0 0 : C O D E
T I M E
Programming Procedures
1 Go off-line.
2 Press LK1 + LK9 + KK
3 Use the dial pad to enter the data.
Setting Data:
2-digit DISA ID Code: 00~99 (00 no data)
3-digit DISA ID Code: 000~999 (000 no data)
4-digit DISA ID Code: 0000~9999 (0000 no data)
Note: Use the following to enter data:
J
to move the cursor left
L to move the cursor right
K I
~ to enter numeric data
R
to access the next ID buffer number
Q
+1, 2, 3 = A, B, or C for Port Number
ID Buffer Number:
01~99
A0~A9
B0~B9
C0
N
4 Press to write the data.
5 Repeat Steps 3 and 4 for each remaining sequential ID Buffer No. displayed after each password choice is made
in Memory Block 1-9-02.
P
Press to go back on-line.
6
Related Programming
No related programming is necessary for this Memory Block.
N
1. Assign 000 (No Data) for stations that are not installed or stations that are denied DISA access.
2. This Memory Block cycles through ID Buffer Nos. alternating with Memory Block 1-9-02 password specification for
each Buffer No.
1-9-00, DISA/ID Code Assignment
Setting
Title Data
= 1 0 0
D I S P L A Y
to access the Memory Block.
Programming Manual
1-9-00
System Mode
Submode
Data No.
PC Programming
Default Values
If DISA ID Code is assigned as 2-digit:
ID Buffer Number 01~10 = DISA ID
Code 10~19
ID Buffer Number 11~20 = DISA ID
Code 20~29, etc.
If DISA ID Code is assigned as 3-digit:
ID Buffer Number 01~C0 = DISA ID
Code 100~219
If DISA ID Code is assigned as 4-digit:
ID Buffer Number 01~10 = DISA ID
Code 1000~1009
ID Buffer Number 11~20 = DISA ID
Code 1010~1019, etc.
DRAFT 3
Chapter 1 – 255
1
9
00
+ BD