Programming Procedures; Go Off-Line; Press Lk1 + Lk4; Automated Attendant Direct Extension Ring Or Ring Assignment - NEC Xen IPK Programming Manual

Xen IPK
Automated Attendant Direct
Extension Ring or Ring
Assignment
General Description
Use this Memory Block to ring at an extension or normal ringing after the AA PBR timer expires
Display
Data
No. Title
2 2 : A A T R F 1
T I M E

Programming Procedures

1 Go off-line.

2 Press LK1 + LK4 +

AC
3 Use the dial pad to enter data.
Note: Use the following to enter data:
J to move the cursor LEFT
J
to move the cursor RIGHT
K ~ I to enter numeric data
2-Digit Station Number: 10~99
3-Digit Station Number: 100~999
4-Digit Station Number: 1000~9999
H to clear all data when cursor is at setting position (Depends what length the
N
4 Press to write the data, and advance to the next A.A.No.
5 After the last entry, press
P
6 Press to go back on-line.
Related Programming
M.B. Number
Refer to
N
1. If extension number is not assigned, then the system follows the assignment of MB 1-4-08 (release or becomes a
normal call).
2. The extension number can be physical, CAR or AA message.

1-4-22, Automated Attendant Direct Extension Ring or Ring Assignment

A.A. Msg.
No.
Setting
1~8
Data
=
D I S P L A Y
to access the Memory Block.
extension number has been assigned in HB1-2-03.)
N
to write the data.
Chapter 2, Guide to Feature Programming.
Memory Block Name
Programming Manual
System Mode
1
Submode
4
Data No.
22
PC Programming
+ AU
Default Values
Not assigned.
DRAFT 3
Chapter 1 – 189
1-4-22