NEC Xen IPK Programming Manual page 36

December 2004
LK 1 System Mode
LK 4 Transfer/Automated Attendant (A.A.) (Continued)
Data
Memory Block Name
No.
21 Automated Attendant Extension Number
Assignment
22 Automated Attendant Direct Extension
Ring or Ring Assignment
LK 1 System Mode
LK 5 SMDR/LCR
Data
Memory Block Name
No.
02 SMDR Print Format
13 Printer Connected Selection
14 Printer Line Feed Control Selection
23 Outgoing Mode Selection
25 SMDR Valid Call Timer Assignment
26 SMDR Incoming/Outgoing Print Selection
LK 1 System Mode
LK 6 DSS
Data
Memory Block Name
No.
00 Attendant Add-On Console to Telephone
Port Assignment
03 DSS Call Voice/Tone Signal Selection
05 Attendant Add-On Console Key Selection
08 Attendant Transfer Selection During Live
Record
16 – Chapter 1
Default Value
Not Specified
Not Specified
Default Value
All
No
No
00 = 0 sec.
All
Default Value
Refer to Attendant Add-On Console to Telephone Port Assignment on page 1-197.
Voice
Refer to Attendant Add-On Console Key Selection on page 1-199.
Yes
DRAFT 3
NEC Business Solutions Ltd
Programming Values
Tel No. (Up to 4 digits) phantom number only
(for each AA message 1~8)
Tel No. (Up to 4 digits) real extension number
or CAR (for each AA message 1~8)
Programming Values
All, Mask Digits
No, PC, Printer
Yes, No
00~99 sec. (input value) x 10 sec.
All, Outgoing, Incoming
Programming Values
Tone, Voice
No, Yes
Multiline Terminal Programming