Line Key Selection For Telephone Mode - NEC Xen IPK Programming Manual

Xen IPK
Line Key Selection for
Telephone Mode
General Description
Use this Memory Block to assign functions to each CO/PBX line key on each telephone in a
tenant specified as Telephone Mode in Memory Block , 2-05 , Line Key Selection.
Display
Tel Port
No.
Data
(01~99)
No.
A0~C0
0 1 / 1 2 : L 0 1 = C O
T I M E
Settings
LK 1 LK 2
Not Specified CO/PBX Line
LK 5 LK 6
Call Feature
Appearance Access
LK 9 LK 10
Microphone
SIE/CAR
Key
LK 13 LK 14
DND LOG
On/Off On/Off
Programming Procedures
Go off-line.
1
2 Press LK4 + AB to access the Memory Block.
3 Press corresponding CO/PBX line key to change setting data 1.
Note: Use the following to enter data:
J to move the cursor left
L
to move the cursor right
K ~ I to enter setting data 2
R
to move to the next Tel Port No
For example, to assign Trunk Group 5 to CO/PBX line key 1, press LK7 to
display TKGP, and enter 05 (for RT 05) using the dial pad.
N
4 Press to write the data and display the next line key.
Repeat example and step 4 until all line key assignments are complete, and press
5
P
Press to go back on-line.
6

4-12, Line Key Selection for Telephone Mode

Line Key No. Setting Setting
(01~24) Data 1 Data 2
0 1
D I S P L A Y
LK 3 LK 4
CFW-B/NA CFW-ALL
LK 7 LK 8
Route
Trunk Group
Advance
LK 11 LK 12
Scroll Key for
Headset
Caller ID
LK 15 LK 16
BGM
ICM
On/Off
The shaded area indicates
the default setting.
Programming Manual
4-12
System Mode
Submode
Data No.
PC Programming
Default Values
For Tel 01~CO: LK01~08 Assigned to
CO/PBX lines 01~08.
N
to enter last data
DRAFT 3
4
—
12
+ BTM
.
Chapter 1 – 419