Caller Id Display For Car Key - NEC Xen IPK Programming Manual

December 2004

Caller ID Display for CAR Key

General Description
This Memory Block assigns one Multiline Terminal per CAR to display Caller ID Indication on
incoming CAR calls.
This memory block is not applicable to IPK R2000 and above.
Display
CAR Port Data
No. No.
0 1 / 4 9 : C A L L
T I M E
Programming Procedures
Go off-line.
1
2 Press LK1 + LK10 + KF
3 Use the dial pad to enter Setting Data.
Note: Use the following to enter data:
J
to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
R
to select next CAR No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
To display Caller ID Indication for normal incoming CO calls and CAR incoming calls, both Caller ID Indication and Ring
assignment must be assigned for the terminal in System Programming. A maximum of 15 Multiline Terminals can be
assigned system-wide to display caller identification for normal incoming CO calls and CAR incoming calls using Memory
Block , 1-1-78 , Caller ID Display Assignment for System Mode. A sixteenth Multiline Terminal can be assigned to display
caller identification for CAR incoming calls per CAR using this Memory Block.
DRAFT 3
454 – Chapter 1
Tel Port No.
(01~99)
Title
A0~C0
I D 0 0
D I S P L A Y
to access the Memory Block.
NEC Business Solutions Ltd
4-49
System Mode
Submode
Data No.
PC Programming
Default Values
Not Specified
Caller ID Display for CAR Key, 4-49
4
—
49
+ AI