Automated Attendant Delay Announcement Assignment - NEC Xen IPK Programming Manual

Xen IPK
Automated Attendant Delay
Announcement Assignment
General Description
Use this Memory Block to specify the order for the Automated Attendant messages that are
played when in the Delayed Announcement Mode.
Display
1st
Message
Data
No.
No.
1 8 : ( 1 )
T I M E
Settings
LK 1 LK 2
Not Specified
MSG1
(NONE)
LK 5 LK 6
MSG4 MSG5
LK9 LK10
MSG8
Programming Procedures
1 Go off-line.
Press LK1 + LK4 +
2 AH
3 Use the dial pad to enter the 1 st message number.
Use the Line Key to enter the Setting Data.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
N
will write the selected data and advance to Memory Block , 1-4-19 , Automated Attendant 1 st to 2 nd
4 Pressing
Delay Announcement Interval Time Selection
P
5 Press to go back on-line.
Related Programming
M.B. Number
Automated Attendant 1 st to 2 nd Delay Announcement Interval Time Selection
1-4-19
1-4-20 Automated Attendant Delay Announcement Disconnect Time Selection
N
1. This Memory Block must be set to YES for Automated Attendant to be enabled.
2. This Feature is not related to Memory Block , 3-43 , ACD/UCD Delay Announcement Assignment.

1-4-18, Automated Attendant Delay Announcement Assignment

Setting Data
2nd
Message No.
Title
2 N D = N O N E
D I S P L A Y
LK 3 LK 4
MSG2 MSG3
The shaded area indicates
LK 7 LK 8
the default setting.
MSG6 MSG7
LK11 LK12
to access the Memory Block.
Memory Block Name
Programming Manual
System Mode
1
Submode
4
Data No.
18
PC Programming
+ AU
Default Values
1 st Message No. 1~8 : Not Specified
DRAFT 3
Chapter 1 – 185
1-4-18