Slt Or Automated Attendant/Disa To Pbr Selection - NEC Xen IPK Programming Manual

Xen IPK
SLT or Automated Attendant/
DISA to PBR Selection
General Description
Use this Memory Block to specify whether the four Push Button Receiver (PBR) circuits in the
CPUI( )-U( ) ETU Unit are used for Single Line Telephones or the Automated Attendant/Direct
Inward System Access (DISA).
Display
Data
No.
0 1 : P B R ( S L T / A A )
T I M E
Settings
LK 1 LK 2
PBR 1 PBR 3
and 2 and 4
LK 5 LK 6
Programming Procedures
Go off-line.
1
Press LK1 + LK8 +
2 KA
3 Press the corresponding CO/PBX line key to change the data option.
The LED indication changes to indicate the data each time the CO/PBX line key is pressed.
CO/PBX
Line LED
Data
N
Press to write the data.
4
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. If LK1 and LK2 are assigned to Automated Attendant/DISA, the PBR( )--13 ETU must be installed in the system if
Single Line Telephones are used.
2. For Automated Attendant to function at least one PBR must be set.

1-8-01, SLT or Automated Attendant/DISA to PBR Selection

Title
D I S P L A Y
LK 3 LK 4
There is no
default setting.
LK 7 LK 8
to access the Memory Block.
Off On
Single Line
A.A./DISA
Telephone
The shaded area indicates
the default setting.
Programming Manual
1-8-01
System Mode
1
Submode
8
Data No.
01
PC Programming
+ BTI
DRAFT 3
Chapter 1 – 217