Tie Line Delay Ringing Timer Selection - NEC Xen IPK Programming Manual

Xen IPK
Tie Line Delay Ringing
Timer Selection
General Description
A Tie line call ringing at a station can begin ringing at other preassigned stations if it is not
answered in a predetermined time. This Memory Block defines the time, and CO/PBX Ringing
Assignment defines the preassigned station.
With IPK R2000 and above, this memory block allows flexible entries and has four classes.
For R2000 only.
Display
Data
No.
0 7 : T L
T I M E
Settings
LK 1 LK 2
10 sec. 20 sec.
LK 5 LK 6
For R2000 and above.
Display
Data
No.
0 7 : T L
T I M E
Programming Procedures
Go off-line.
1
2 Press LK1 + LK1 + KG
3 Use the dial pad to enter the time required.
Note: J to move cursor left.
L to move cursor right.
Setting Data (Allow): Class 1 to Class 4: 000 to 255 sec
N
4 Press to write the data.
P
Press to go back on-line.
5

1-1-07, Tie Line Delay Ringing Timer Selection

Setting
Title Data
∞
D L Y R N G
D I S P L A Y
LK 3 LK 4
∞
30 sec.
The shaded area indicates
the default setting.
LK 7 LK 8
Setting
Title Data
D L Y X = 0 0 0
D I S P L A Y
to access the Memory Block.
000 = No Limit
s
Default values:
Class 1 to Class 4 = 000 secs (unlimited)
Programming Manual
1-1-07
System Mode
1
Submode
1
Data No.
07
PC Programming
+ BCM
DRAFT 3
Chapter 1 – 41