Internal Zone Paging Selection - NEC Xen IPK Programming Manual

December 2004
Internal Zone Paging
Selection
General Description
Use this Memory Block to place stations in Internal page zones.
Display
Tel Port No.
Data
(01~99)
No.
A0~C0
0 1 / 9 3 : Z O N E
T I M E
Settings
LK 1 LK 2
No Zone A
LK 5 LK 6
Programming Procedures
1 Go off-line.
2 Press LK4 + to access the Memory Block.
IC
Press the corresponding CO/PBX line key to change data option.
3
Note: Use the following to change option:
R
select next Tel Port No.
N
4 Press to write the data.
P
Press to go back on-line.
5
Related Programming
No related programming is necessary for this Memory Block.
N
1. Specify one zone:
All Internal Zones: Paged by dialling 51
Zone A:
Zone B:
Zone C:
2. Telephones can be assigned to NO Zone. All Internal Zones page the telephone unless No Page Receive is assigned
in Memory Block , 4-31 , Receiving Internal/All Call Page Selection.
3. All Internal Zones pages all of the idle Multiline Terminals.
4. Telephone ports A0~C0 are ports 100~120.
DRAFT 3
478 – Chapter 1
Setting
Title Data
N O
D I S P L A Y
LK 3 LK 4
Zone B Zone C
The shaded area indicates
the default setting.
LK 7 LK 8
Paged by dialling 52
Paged by dialling 53
Paged by dialling 54.
NEC Business Solutions Ltd
4-93
System Mode
4
Submode
—
Data No.
93
PC Programming
+ BTM

Internal Zone Paging Selection, 4-93