Second Delay Announcement Repeat Selection - NEC Xen IPK Programming Manual

Xen IPK
Second Delay Announcement
Repeat Selection
General Description
Use this Memory Block to specify the number of times a Second Delay Announcement is
repeated.
Display
Data
No.
7 4 : M S G 2
T I M E
Settings
LK 1 LK 2
1 Time 2 Times
LK 5 LK 6
5 Times 6 Times
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 + GD
3 Press the corresponding CO/PBX line key to change the data option.
N
Press to write the data.
4
P
5 Press to go back on-line.
Related Programming
M.B. Number
1-1-73 First to Second Delay Announcement Interval Time Selection
1-1-75 Second Delay Announcement Repeat Interval Time Selection
1-8-12 VRS Message Recording Time Selection
1-8-13 VRS Message Function Assignment
3-43 ACD/UCD Delay Announcement Assignment
N
1. This Memory Block does not display unless the MIFA-U( ) ETU is installed.
2. This Memory Block does not display unless the MIFA-U( ) ETU is installed.
3. When Memory Block 2-08 is used, this is the number of times the message is played back-to-back. After this is done,
the system looks at 1-1-75 to repeat the procedure.

1-1-74, Second Delay Announcement Repeat Selection

Setting
Title Data
S E N D = 1
D I S P L A Y
LK 3 LK 4
3 Times 4 Times
The shaded area indicates
the default setting.
LK 7 LK 8
7 Times 8 Times
to access the Memory Block.
Memory Block Name
Programming Manual
1-1-74
System Mode
1
Submode
1
Data No.
74
PC Programming
+ AR
DRAFT 3
Chapter 1 – 115