Trunk-To-Trunk Group Assignment - NEC Xen IPK Programming Manual

Xen IPK
Trunk-to-Trunk Group
Assignment
General Description
Use this Memory Block to assign a Trunk Group Number (01~32) to each CO/PBX line.
Display
CO/PBX
No.
Data
(01~64)
No.
0 1 / 0 3 : T R K
T I M E
Programming Procedures
Go off-line.
1
N
2 Press LK3 + +
3 Enter data using the dial pad.
Note: Use the following enter data:
J
to moves the cursor left
L to moves the cursor right
K ~ I to enter numeric data
R
to go to the next CO/PBX Line No.
Setting Data
00 : Not set
01~32 : Trunk Group 01~32
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. When an Access Code corresponding to a Trunk Group is dialled, an idle CO line is selected automatically and seized
from the same Trunk Group dialled (the CO line of either same tenant or another tenant can be seized).
2. By specifying the priority order, up to four routes (Trunk Groups) can be selected in Memory Block 1-1-30 Route
Advance Block Assignment. Idle CO lines are selected and seized in this sequence.
3. If LCR is installed, Local Trunks should be assigned to Trunk Group 1. When a number is dialled that bypasses LCR,
the system accesses Trunk Group 1 and dials the number.

3-03, Trunk-to-Trunk Group Assignment

Trunk Group
Title No. (01~32)
G P = 0 1
D I S P L A Y
KC to access the Memory Block.
Programming Manual
System Mode
Submode
Data No.
PC Programming
Default Values
CO/PBX lines (01~08) in Trunk Group 01
CO/PBX lines (09~64) in Trunk Group 00
All Tie lines in Trunk Group 02
All DID lines in Trunk Group 00
All ISDN lines in Trunk Group 00
DRAFT 3
Chapter 1 – 341
3-03
3
—
03
+ BCT