Xen IPK
T1 Signal Format Selection
General Description
Use this Memory Block to specify the signal format of the T1 trunk connected to the
system. The signal format used (12- or 24-Multiframe) depends on the channel service unit/
demarcation (CSU/D mark) equipment being used.
System Software R2000 or higher is required.
Display
DTI No.
Data
(01~03)
No.
0 1 / 0 0 : F R A M E
T I M E
Settings
LK1
LK2
12
24
(SF)
(ESF)
Programming Procedures
Go off-line.
1
Press LK1 + LK11 to access the Memory Block.
2
Press the corresponding CO/PBX line key to change the data option.
3
Note:
Setting Data:
SF = Superframe Format (12-Multiframe)
ESF = Extended Superframe Format (24-Multiframe)
N
Press
to write the data. The next Memory Block is displayed.
4
Program the next Memory Block or press
5
Related Programming
M.B. Number
7-1
Card Interface Slot Assignment
Related Programming
No related programming is necessary for this Memory Block.
N
The DTI-U( ) ETU must be assigned in the system to set this Memory Block.
1-11-00, T1 Signal Format Selection
Setting
Title
Data
= 2 4
D I S P L A Y
LK3
LK4
LK5
P
to go back on-line.
LK6
LK7
Memory Block Name
Programming Manual
1-11-00
System Mode
1
Submode
11
Data No.
00
PC Programming
+ AD
LK8
The shaded area indicates
the default setting.
DRAFT 3
Chapter 1 – 261