Intercom Ring Tone Selection - NEC Xen IPK Programming Manual

Xen IPK

Intercom Ring Tone Selection

General Description
Use this Memory Block to select a ring tone for intercom calls.
Display
Data
No.
2 0 : I C M
T I M E
Settings
LK 1 LK 2
Tone A Tone B
LK 5 LK 6
Tone E Tone F
Programming Procedures
1 Go off-line.
2 Press LK1 + LK2 +
BK
3 Press the corresponding CO/PBX line key to change the data option.
N
Press to write the data.
4
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
The available tones are:
Tone A = (480/600):
Tone B = (480/606):
Tone C = (1024/1285)
Tone D = (1024)
Tone E = (500)
Tone F = (1024/1285):
Tone G = (600/700):
Tone H = (1024)
1-2-20, Intercom Ring Tone Selection
Setting
Title Data
T O N E A
D I S P L A Y
LK 3 LK 4
Tone C Tone D
The shaded area indicates
the default setting.
LK 7 LK 8
Tone G Tone H
to access the Memory Block.
Modulation (16 Hz)
Modulation (8 Hz)
Modulation (16 Hz)
Modulation (16 Hz)
Envelope 2 sec.
Programming Manual
1-2-20
System Mode
1
Submode
2
Data No.
20
PC Programming
+BI
DRAFT 3
Chapter 1 – 139