NEC Xen IPK Programming Manual page 636

December 2004
DRAFT 3
616 – Chapter 3
Disconnect
This option allows the technician to disconnect from the Xen IPK
system.
Upload
This option allows the technician to upload programming changes
and configurations to the KTS.
Download
This option allows the technician to download the current Xen
configuration.
Verify
This option allows the technician to compare the configuration
programmed in the KTS with that of the PC.
First Initialisation
This option reinitialises the system to the factory-set defaults.
All active calls on the system are dropped.
Second Initialisation
This option reboots the system without resetting the programmed
defaults (i.e., all programming is retained).
Setup
This option allows the technician to set up the system to provide
communication. Four options are available for this selection.
PC Serial Port — serial port of the PC that is connected to
the KTS.
End User Password — the password programmed in Memory
Block 1-8-17 on the KTS.
Site Name — the name of the site that is being programmed.
Setup & Initialise — the KTS port settings/configurations.
NEC Business Solutions Ltd
Section 7, Xen IPK Pulldown Menus