Centralised Billing Allow/Deny Selection - NEC Xen IPK Programming Manual

December 2004
Centralised Billing Allow/
Deny Selection
General Description
Use this Memory Block to assign the
Office (NEAX2000/2400) across the K-CCIS network. Xen IPK does not support receiving
and managing billing information
Applicable for IPK R2000 and above.
Display
Data
No.
1 1 : B I L L I N G
T I M E
Settings
LK1 LK2
NO YS
(Deny) (Allow)
Programming Procedures
1 Go off-line.
2 Press LK1 + LK15 + AA
3 Press the corresponding CO/PBX line key to change the option.
N
Press to write the data.
4
P
Press to go back on-line.
5
Related Programming
M.B. Number
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
DRAFT 3
312 – Chapter 1
Electra Elite IPK
.
Setting
Title Data
N O
D I S P L A Y
LK3 LK4 LK5
to access the Memory Block.
to send billing to the Billing Center
LK6 LK7
Memory Block Name

Centralised Billing Allow/Deny Selection, 1-15-11

NEC Business Solutions Ltd
System Mode
1
Submode
15
Data No.
11
PC Programming
+ AW
LK8
The shaded area indicates
the default setting.
1-15-11