System Speed Dial Memory Clear - NEC Xen IPK Programming Manual

Xen IPK
System Speed Dial Memory
Clear
General Description
Use this Memory Block to clear all System Speed Dial programming.
N
Before programming this procedure, please ensure you understand completely the
affect of erasing all System Speed Dial buffers in the system.
Display
C L R S Y S
T I M E
Programming Procedures
1 Go off-line.
2 Press LK8 + LK2 to access the Memory Block.
3 When the system display prompt indicates CLR TEL SPD?, the first four CO/PBX lines light red.
WWWW
Red Red Red
4 Press HAHI
Note: When entering the password the top line of CO/PBX LEDs change from red to green each time a number of the password
is pressed.
WWWW
H =
Green
WWWW
A =
Green
WWWW
H =
Green
WWWW
I =
Green
N
Press to write the data.
5
P
6 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.

8-2, System Speed Dial Memory Clear

S P D ?
D I S P L A Y
Red
to enter the fixed password.
Red Red Red
Green Red Red
Green Green Red
Green Green Green
Programming Manual
System Mode
8
Spd-Clr-Sys
2
Data No.
—
PC Programming
+ BE
DRAFT 3
Chapter 1 – 515
8-2