Trunk (Installed, Dp/Dtmf) Selection - NEC Xen IPK Programming Manual

December 2004
Trunk (Installed, DP/DTMF)
Selection
General Description
This Memory Block specifies each external line as DP (10 pps or 20 pps) or DTMF line or not
connected (NIL).
Display
CO/PBX
Data
No.
No.
(01~64)
0 1 / 9 2 : M F
T I M E
Settings
LK 1 LK 2
NIL DP 10 pps
LK 5 LK 6
Programming Procedures
1 Go off-line.
N
2 Press LK3 + +
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
J
to move the cursor left
L to move the cursor right
R
to go to the next CO/PBX Line No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
3-14 Tie/DID Line Type Assignment
4-12 Line Key Selection for Telephone Mode
N
1. When Port 01 displays CO XX layer message, use NIL setting for unused BRI interfacing to clear display.
2. Only Tie lines and Direct Inward Dialling (DID) trunks can use dial pulse on the Xen IPK System. All other trunks must
be set to multi frequency (MF).
DRAFT 3
404 – Chapter 1
Setting
Data
D I S P L A Y
LK 3
DP 20 pps
LK 7
IB to access the Memory Block.
LK 4
MF
The shaded area indicates
the default setting.
LK 8
Memory Block Name

Trunk (Installed, DP/DTMF) Selection, 3-92

NEC Business Solutions Ltd
System Mode
3
Submode
—
Data No.
92
PC Programming
+ BCT
3-92