Automatic Redial Time Selection - NEC Xen IPK Programming Manual

December 2004
Automatic Redial Time
Selection
General Description
If a called party is busy, the station user dials an Access Code and restores the handset. Use this
Memory Block to define the redial timing parameters when automatic redial is set to a busy CO/
PBX number. After the specified number of call attempts with no answer, the system stops
dialling.
Display
Data
No.
0 4 : R E D I A L ( X )
T I M E
Programming Procedures
Go off-line.
1
2 Press LK1 + LK1 + KD
3 Use the dial pad to enter the Table Number and Setting Data.
Note: Use the following to enter data:
J
to move the cursor left
L to move the cursor right
Setting Data (Allowed):
Table 1 (Calling Time):
Table 2 (Call Waiting Time):
Table 3 (Call Attempts):
Note: 000 cannot be entered.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. Definitions:
Calling Time:
Call Waiting Time: The time the system waits between call attempts.
Call Attempts:
2. If Call Pickup Groups are assigned using Memory Block 4-09 Telephone to Tenant Assignment, the CO lines must be
assigned to the same Tenant Group in Memory Block 2-01 Trunk to Tenant Assignment for this feature to work.
DRAFT 3
36 – Chapter 1
Setting
Table
Title Data
0 3 0
D I S P L A Y
to access the Memory Block.
001~050 sec.
001~100 sec.
001~009 times (3 digit input)
The time that the system automatically calls the busy CO/PBX number. After the specified time
limit is reached, the call is abandoned.
The number of times the system redials the busy CO/PBX number.
X = 1, 2, 3
Default Values
Table No.
1
2
3

Automatic Redial Time Selection, 1-1-04

NEC Business Solutions Ltd
1-1-04
System Mode
1
Submode
1
Data No.
04
PC Programming
+ BM
Description Value
Calling Time 30 sec.
Call Waiting Time 60 sec.
Call Attempts 2