Pbx/Ctx Access Code Assignment Ii - NEC Xen IPK Programming Manual

Xen IPK
PBX/CTX Access Code
Assignment II
General Description
Use this Memory Block to specify a second PBX line PBX/CTX Access Code together with
pauses for outgoing calls.
Display
Data
No.
2 5 : P B X
T I M E
Programming Procedures
Go off-line.
1
2 Press LK1 + LK1 + BE
3 Enter the option using the dial pad.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K I
~ to enter numeric data
Q
to insert a pause (cannot be first digit)
U
to clear all data
N
4 Press to write the data.
P
Press to go back on-line.
5
Related Programming
M.B. Number
3-92 Trunk Type Selection
N
Example:
1. Features such as Code Restriction do not operate properly unless a PBX/CTX Access Code is specified. This
limitation only applies to PBX lines assigned in Memory Block 3-92 Trunk Type Selection.
2. A pause is not inserted in the number of an outgoing call on a CO line.
3. Up to three numeric characters and three pauses can be specified.
4. A pause cannot be inserted as the first or as consecutive digits.

1-1-25, PBX/CTX Access Code Assignment II

Setting
Title Data
A C 8 -
D I S P L A Y
to access the Memory Block.
Xen IPK System
Intercom Line
Memory Block Name
Xen IPK
PBX
PBX Line
Programming Manual
1-1-25
System Mode
1
Submode
1
Data No.
25
PC Programming
+ BA
Default Values
8-
Tie Line
DRAFT 3
Chapter 1 – 61