Prt B Channel Outgoing Priority Selection - NEC Xen IPK Programming Manual

Xen IPK
PRT B Channel Outgoing
Priority Selection
General Description
Use this Memory Block to assign the Outgoing Priority for the B-channels when calls are
originated on a PRT(1)-U( ) ETU.
This assignment is allowed by handset programming and SAT.
Display
PRT Data
(1-2) No.
0 1 / 0 4 : C H
T I M E
Settings
LK 1 LK 2
H L L H
High to Low Low to High
Programming Procedures
1 Go off-line.
2 Press LK1+ LK13 +
KD
Press the corresponding CO/PBX line key to change the data option.
3
N
4 Press to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
Related Programming
M.B. Number
7-1 Card Interface Slot Assignment
1-13-00 PRI Channel Assignment
N
This Memory Block applies to all firmware versions of the PRT(1)-U( ) ETU.

1-13-04, PRT B Channel Outgoing Priority Selection

Setting
Title
Data
S L C = H L
D I S P L A Y
LK 3 LK 4
to access the Memory Block.
P
to go back on-line.
LK 5 LK 6
Memory Block Name
Programming Manual
System Mode
Submode
Data No.
PC Programming
LK 7 LK 8
The shaded area
indicates the
default setting.
DRAFT 3
1-13-04
1
13
04
+ AN
Chapter 1 – 277