Hookflash Time Selection - NEC Xen IPK Programming Manual

Xen IPK

Hookflash Time Selection

General Description
Use this Memory Block to specify the loop open time for a hookflash signal sent to the CO or
PBX when the Recall key on a Multiline Terminal is pressed. A Single Line Telephone (SLT)
generates a hookflash to the CO or PBX line when a Single Line Telephone hookflash
is assigned.
Display
Data
No.
Title
0 2 : F L S H
T I M E
Settings
(Page 1)
LK 1 LK 2
20 ms. 40 ms.
LK 5 LK 6
100 ms. 140 ms.
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
KB
Press the corresponding CO/PBX line key to change the data option.
3
Note: Use the following to enter data:
S
to go to the next page
T
to go to the previous page
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
1-1-46 Access Code (1-Digit) Assignment
1-1-47 Access Code (2-Digit) Assignment
1-3-02 SLT Hookflash Signal Selection
4-24 SLT Hookflash Assignment
N
1. A 1- or 2-digit Access Code can be assigned in Memory Block 1-1-46 Access Code (1-Digit) Assignment and
Memory Block 1-1-47 Access Code (2-Digit) Assignment, for Single Line Telephones to send a hookflash signal on a
CO/PBX line (default: 6 #).
2. A hookflash from a Single Line Telephone puts an existing call on hold or sends a hookflash signal on the CO/
PBX line.
1-1-02, Hookflash Time Selection
Setting
Data
1 0 0 m s
D I S P L A Y
LK 3 LK 4
60 ms. 80 ms.
LK 7 LK 8
160 ms. 200 ms.
to access the Memory Block.
Page
No.
1
(Page 2)
LK 1 LK 2
400 ms. 600 ms.
LK 5 LK 6
1.5 sec. 2 sec.
Memory Block Name
Programming Manual
1-1-02
PC Programming
LK 3 LK 4
800 ms. 1 sec.
The shaded area indicates
the default setting.
LK 7 LK 8
3 sec. 5 sec.
DRAFT 3
System Mode
1
Submode
1
Data No.
02
+ BCM
Chapter 1 – 33