Trunk Status Selection - NEC Xen IPK Programming Manual

December 2004

Trunk Status Selection

General Description
Use this Memory Block to specify whether a CO/PBX line is used for call origination and
termination or termination only.
Display
CO/PBX
No.
Data
(01~64)
No.
0 1 / 0 2
T I M E
Programming Procedures
1 Go off-line.
N
2 Press LK3 + +
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
R
to go to the next CO/PBX Line No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
DRAFT 3
340 – Chapter 1
Title
O U T & I N
D I S P L A Y
KB to access the Memory Block.
NEC Business Solutions Ltd
System Mode
3
Submode
—
Data No.
02
PC Programming
+ BCT
Trunk Status Selection, 3-02
3-02