Hold/Transfer Recall Display Selection - NEC Xen IPK Programming Manual

December 2004
Hold/Transfer Recall Display
Selection
General Description
Use this memory block to enable/disable the Hold Recall indication on the LCD.
Display
Tel Port No.
Data
(01~99)
No.
A0~C0
0 1 / 3 0 : H L D
T I M E
Settings
LK 1 LK 2
Ys No
LK 5 LK 6
Programming Procedures
1 Go off-line.
2 Press LK4 + to access the Memory Block.
CK
Press the corresponding CO/PBX line key to change data option.
3
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. If this Memory Block is assigned Yes, the Hold Recall is displayed in place of the Time Display.
2. LCD indication of the CO line number is displayed on the upper line of the display when a recall occurs, regardless of
the assignment for this Memory Block.
3. Telephone ports A0~C0 are ports 100~120.
DRAFT 3
436 – Chapter 1
Setting
Title Data
D S P Y S
D I S P L A Y
LK 3 LK 4
The shaded area indicates
the default setting.
LK 7 LK 8
NEC Business Solutions Ltd
4-30
PC Programming

Hold/Transfer Recall Display Selection, 4-30

System Mode
4
Submode
—
Data No.
30
+ BTM