Trunk Name/Number Assignment - NEC Xen IPK Programming Manual

Xen IPK
Trunk Name/Number
Assignment
General Description
Use this Memory Block to specify telephone name/number for the CO/PBX lines accommodated
so that the information is displayed when the CO/PBX Line is seized, or during an incoming call.
With IPK R2000 and above this memory block is not applicable.
Display
CO/PBX No.
(01~64)
0 1 /
T I M E
Settings
LK 1 LK 2
Number Name
LK 5 LK 6
Programming Procedures
1 Go off-line.
2 Press LK3 +
KK
Use the dial pad to enter data.
3
Note: Use the following enter data:
J to moves the cursor left
L to moves the cursor right
K I
~ to numeric keys for entering data
Q
to generate a - (hyphen)
U
to generate a s
R
to go to the next CO/PBX Line No.
N
4 Press to write the data.
P
Press to go back on-line.
5
Related Programming
No related programming is necessary for this Memory Block.
N
When a name is selected, refer to
get the character codes.

3-00, Trunk Name/Number Assignment

Setting Data
(13 digits maximum)
D I S P L A Y
LK 3 LK 4
The shaded area indicates
the default setting.
LK 7 LK 8
to access the Memory Block.
pace (clear after hold)
Section 7, Character Code Tables
PC Programming
Default Values
Not Specified
7.1 Dial Pad Character Assignment on page 1-541
,
DRAFT 3
Programming Manual
3-00
System Mode
3
Submode
—
Data No.
00
+ BCT
to
Chapter 1 – 339