Intercom Call Voice/Tone Signal Selection - NEC Electra Elite IPK Programming Manual

Electra Elite IPK
___________________________________________________________________________________
1-2-01 Intercom Call Voice/Tone Signal
Selection
General Description
Use this Memory Block to specify whether signal tone or voice is used first for an
intercom call.
Display
S e t t i n g
D a t a
N o .
0 1 : V O I C E
T I M E
Settings
LK 1 LK 2
TONE VOICE
Programming Procedures
1 Go off-line.
K A
2 Press LK1 + LK2 +
3 Press the corresponding CO/PBX line key to change the data option.
G
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
1-6-03
DSS Call Voice/Tone Signal Selection
1. To switch from voice to tone signaling or from tone to voice, dial a station number, then dial 1.
2. When tone signaling is programmed in this Memory Block, the called party cannot answer handsfree unless the
originator of the call dials 1.
3. This Memory Block has no effect on incoming Voice Announcement Tie/DID line calls. Refer to Memory Block
1-1-34 (Tie Line First Ring Pattern Selection).
___________________________________________________________________________________
Programming Manual
T i t l e
D a t a
C A L L
D I S P L A Y
LK 3 LK 4
t o access the Memory Block.
E
LK 5 LK 6 LK 7
to go back on-line.
Notes
Document Revision 4
System Mode
1
Submode
2
Data No.
01
PC Programming
+BI
LK 8 The shaded
selection is the
default.
2 - 107