Private Line Assignment - NEC Xen IPK Programming Manual

Xen IPK

Private Line Assignment

General Description
Use this Memory Block to assign an outside line for use as a private line. The private line cannot
be seized by any other telephone, and no LED indication is provided to other terminals.
Display
Combination
No.
Data
(1/2)
No. Title
2 9 : P 1
T I M E
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 + BI
3 Enter the data using the dial pad.
Note: Use the following to enter data:
J
to move the cursor left
L to move the cursor right
K I
~ to enter numeric data
U
to clear all data when cursor is at CO No. or Tel. Port No.
N
4 Press to write the data. Data for the second line is displayed. Move the cursor to change the data.
N
5 Press to write the data.
P
Press to go back on-line.
6
Related Programming
M.B. Number
2-06 Line Key Selection for Tenant Mode
4-12 Line Key Selection for Telephone Mode
N
1. Two private lines can be assigned to one station or one private line can be assigned to two stations.
2. A Single Line Telephone (SLT) user cannot dial the Trunk Group Access Code to access a private line. The Single
Line Telephone user can access the line by dialling the specified Line Seizure Access Code assigned in Memory
Blocks 1-1-46/ 1-1-47 Access Code (1-digit/2 -digit) Assignment (Function 063 or 064).
3. If a station is allowed Barge-In originate, and a second station is allowed Barge-In receive, Barge-In is not allowed on
a private line unless both stations share the private line.
1-1-29, Private Line Assignment
CO No. Tel. Port No.
(01~64) (01~CO)
C = T =
D I S P L A Y
to access the Memory Block.
Memory Block Name
Programming Manual
1-1-29
System Mode
1
Submode
1
Data No.
29
PC Programming
+ BCS
Default Values
Not Specified
DRAFT 3
Chapter 1 – 65