Common Signalling Channel Route Assignment - NEC Xen IPK Programming Manual

Xen IPK
Common Signalling Channel
Route Assignment
General Description
Use this Memory Block to specify the Common Signalling Channel for each voice trunk
group used for K-CCIS
.
Applicable for IPK R2000 and above.
Display
Trunk Group No. Data
(01~32) No.
0 1 / 0 5 : C C H
T I M E
Settings
LK1 LK2
0 1
Programming Procedures
1 Go off-line.
N
Press LK5+
2
Note: Use the following to enter data:
J
to move cursor left
L to move cursor right
K ~ I to enter numeric data
N
Press to write the data.
3
P
Press to go back on-line.
4
Related Programming
M.B. Number
3-70 CIC Number Assignment
1-1-05 Start Time Selection
1-1-46~48
Access Code (1-, 2- or 3-Digit) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04
Destination Point Code Assignment
1-15-05
Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Time Assignment
1-15-08
Link Reconnect Allow/Deny Selection

5-05, Common Signalling Channel Route Assignment

Setting
Title Data
C H 0
D I S P L A Y
LK3 LK4 LK5
2 3 4
+ to access the Memory Block.
KE
LK6 LK7
Default Values :
0 (Not Assigned)
CCH: 1~4
Memory Block Name
Programming Manual
System Mode
5
Submode
—
Data No.
05
PC Programming
+ AW
LK8
The shaded area indicates
the default setting.
DRAFT 3
Chapter 1 – 489
5-05