NEC Xen IPK Programming Manual page 453

Xen IPK
Programming Procedures
Go off-line.
1
KA
2 Press LK4 +
3 Press the CO/PBX Line key corresponding to each CO/PBX number.
The LED indication changes to indicate data each time a CO/PBX line key
is pressed.
CO/PBX
Line Key LED
Meaning
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
R
to move to the next Tel No.
S
to move to the next page
T
to move to the previous page
Q
+1, 2, 3 = A, B or C for Port Number
Tel Port Number:
01~99 = 01~99
A0~A9 = 100~109
B0~B9 = 110~119
C0 = 120
After entering all data for all pages, press
4
P
5 Press to go back on-line.
Related Programming
M.B. Number
1-1-19 Line Selection for Automatic Outgoing Calls
1-1-46 DID Digit Length Selection
1-1-47 DID Digit Conversion Assignment
1-1-48 DID Forward Station Number for Busy Station or Undefined Digit
1-5-23 Outgoing Mode Selection
1-9-00 DISA/ID Code Assignment
1-9-02 DISA/ID Password Effect/Invalid Selection
1-9-03 ID Restriction Class Assignment (Day Mode)
4-26 DISA/ID Number Station Assignment
N
Telephone ports A0~C0 are ports 100~120.
4-27, ID Outgoing Restriction Selection
to access the Memory Block.
Off On
Not
Available
Available
N
to write the data.
Memory Block Name
Programming Manual
Default Values
All stations = Available for all ID
Numbers.
DRAFT 3
Chapter 1 – 433