Tie Line First Ring Pattern Selection - NEC Xen IPK Programming Manual

Xen IPK
Tie Line First Ring Pattern
Selection
General Description
Use this Memory Block to set specific ringing tones for incoming calls on Tie lines. After a delay
interval specified in Memory Block 1-1-07
ring at all Day/Night ring-assigned telephones using a different cadence.
Display
Data
No.
3 4 : T L I
T I M E
Settings
LK 1 LK 2
Pattern 1 Pattern 2
LK 5 LK 6
ICM Voice
Programming Procedures
Go off-line.
1
2 Press LK1 + LK1 + CD
3 Press the corresponding CO/PBX line key to change the data option.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
1-1-07 Tie Line Delay Ringing Timer Selection
1-1-53 Tie Line Delay Ring Pattern Selection
4-01 CO/PBX Ring Assignment (Day Mode)
4-02 CO/PBX Ring Assignment (Night Mode)
N
1. Specify one pattern in the Ringing Pattern Selection Table.
2. If Voice is selected, switching from voice to tone is not allowed, Memory Block 1-1-07 is not used, and Handsfree
Answerback is not allowed at the receiving station.

1-1-34, Tie Line First Ring Pattern Selection

Tie Line Delay Ringing Timer Selection
Setting
Title
Data
R N G P A T 3
D I S P L A Y
LK 3 LK 4
Pattern 3 Pattern 4
The shaded area indicates
the default setting.
LK 7 LK 8
to access the Memory Block.
, a Tie call can
Memory Block Name
Programming Manual
1-1-34
System Mode
1
Submode
1
Data No.
34
PC Programming
+ ALN
DRAFT 3
Chapter 1 – 71