Timer Class Assignment For Telephone Mode Selection - NEC Xen IPK Programming Manual

December 2004
Timer Class Assignment for
Telephone Mode Selection
General Description
This Memory Block assigns class of flexible timer to Extenstions. Applicable to IPK R2000.
Display
Tel Port No. Data
(01~CO) No.
0 1 / 7 1 : T M R
T I M E
Programming Procedures
Go off-line.
1
2 Press LK4 + GA to access the Memory Block.
3 Use the following to enter data:
J to move the cursor left.
L to move the cursor right.
K I
~ to enter numeric data.
Setting Data (Allow):
1 (Class 1) to 4 (Class 4)
– OR –
R
Press to go to the next TEL port number.
N
Press to write the data and display Memory Block , 4-01.
4
5 Program Memory Block, 4-01 or press
Related Programming
M.B. Number
1-1-03 Hold Recall Timer Selection (Non-Exclusive Hold)
1-1-05 Start Timer Selection
1-1-06 CO/PBX Incoming Ringing Alarm Time Selection
1-1-07 Tie/DID Line Delay Ringing Timer Selection
1-1-12 Station Transfer/Camp-On Recall Timer Selection
1-1-37 Trunk Queuing Timeout Selection
1-1-63 Hold Recall Time Selection (Exclusive)
1-1-81 ISDN Dial Interval Timer
1-2-00 Internal Paging Timeout Selection
DRAFT 3
468 – Chapter 1
Setting
Data
C L S = 1 5
D I S P L A Y
P
to go back on-line.
Default
Class 1
Memory Block Name

Timer Class Assignment for Telephone Mode Selection, 4-64

NEC Business Solutions Ltd
4-64
Submode
4
System Mode
—
Data No.
64
PC Programming
+ BTT