NEC Xen IPK Programming Manual page 544

December 2004
Timer
Automated
Attendant Transfer
Delayed Ringing
Time Selection
Automated
Attendant No
Answer Disconnect
Time Selection
Automated
Attendant Answer
Delay Time
Assignment
Automated
Attendant 1 st to 2 nd
Delay
Announcement
Interval Time
Selection
Automated
Attendant Delay
Announcement
Disconnect Time
Selection
SMDR Valid Call
Timer Assignment
Doorphone Display
Time Selection
External Paging
Timeout Selection
External Speaker
Chime Start Time
Selection
DRAFT 3
524 – Chapter 1
Function Timer Chart (Continued)
Table 1-3:
Memory
Block
Specify the time for a No Answer
1-4-02
at the transferred station before
the Automated Attendant rings a
predetermined station.
Determine how long the
1-4-03
Automated Attendant rings a
station before dropping the call.
Assign the number of seconds
1-4-13
before the Automated Attendant
answers an incoming CO/PBX call
when there is no answer.
Specify the interval time between
1-4-19
the Automated Attendant Delay
Announcement messages
Establishes how long the
1-4-20
Automated Attendant rings the
stations before disconnecting the
caller. Only applies when the
Automated Attendant is set to the
Delay Announcement Mode.
Minimum duration of an outside
1-5-25
call before the system provides an
SMDR report (Set from 0~99
seconds in 10-second
increments).
Define how long a door phone call
1-7-01
signals a station before it times
out.
The time before an external
1-7-06
paging is automatically
disconnected.
Assign the delay after an external
1-7-09
paging code is dialled and before
the paging alert tone is provided.
Only used when paging alert tone
(4 tones) is assigned in Memory
Block 1-7-08 (External Speaker
Chime Selection).
Definition
NEC Business Solutions Ltd
Timing Value
Minimum Default
10 sec. No Limit
1 min. 2 min.
0 sec. 4 sec.
0 min. 4 min.
0 sec. 30 sec.
0 sec. 40 sec.
10 sec. 10 sec.
30 sec. 5 min.
0 ms. 700 ms.
Section 5, Function Timer Chart
Maximum
No Limit
4 min.
99 sec.
20 min.
20 min.
990 sec.
90 sec.
No Limit
1500 ms.