Centralised Day/Night Switching For Main Office Assignment - NEC Xen IPK Programming Manual

December 2004
Centralised Day/Night
Switching for Main Office
Assignment
General Description
Use this Memory Block to assign the Point Codes and the CCH Channel to control remote
systems for Centralised Day/Night Switching
A CCH Channel of i can be assigned for K-CCIS over IP (System Software R2000 or
higher).
Display
Data Table
No. 01~16
1 4 : T 0 1 :
T I M E
Programming Procedures
1 Go off-line.
2 Press LK1 + LK15 +
AC
Use dial pad keys to enter Table number, CCH Channel, and Point Code.
3
Press Redial + 1 to assign i for K-CCIS over IP (System Software R2000 or
higher).
Note: Use the following to enter data:
J
to move cursor left.
L
to move cursor right.
K I
~ to enter numeric data.
Point Code range is 0001~16367.
Tables 01~16 can be assigned.
N
4 Press to write the data, and display the next Memory Block.
5 Repeat Steps 3 and 4 for each table. The next Memory Block is displayed.
6 Program the next Memory Block or p
Related Programming
M.B. Number
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
DRAFT 3
318 – Chapter 1
.
CCH
C-Channel
Point
1~4, 1
Code
= 0
D I S P L A Y
to access the Memory Block.
P
ress to go back on-line.

Centralised Day/Night Switching for Main Office Assignment, 1-15-14

Default Values :
All Tables Not Specified.
Memory Block Name
NEC Business Solutions Ltd
1-15-14
System Mode
1
Submode
15
Data No.
14
PC Programming
+ AW