Hold Recall Timer Selection (Non Exclusive Hold) - NEC Xen IPK Programming Manual

December 2004
Hold Recall Timer Selection
(Non Exclusive Hold)
General Description
Use this Memory Block to specify the time a Non-Exclusive Hold outside call is held until a recall
tone is generated. If No Limit is selected, the hold recall alarm tone is not generated.
With IPK R2000 and above, this memory block allows flexible entries and has four classes.
For R2000 only.
Display
Data
No.
0 3 : H O L D
T I M E
Settings
LK 1 LK 2
25 sec. 45 sec.
LK 5 LK 6
120 sec. 180 sec.
Programming Procedures
Go off-line.
1
2 Press LK1 + LK1 + KC
3 Press the corresponding CO/PBX line key to change the data option.
N
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
For R2000 and above.
Display
Data
No.
0 3 : H L D R C L
T I M E
Programming Procedures
Go off-line.
1
2 Press LK1 + LK1 + KC
3 Use the dial pad to enter the time required.
Note: J to move cursor left.
L to move cursor right.
Setting Data (Allow): Class 1 to Class 4: 000 to 255 sec
DRAFT 3
34 – Chapter 1
Setting
Title Data
R E C L 6 0 s
D I S P L A Y
LK 3 LK 4
60 sec. 90 sec.
The shaded area indicates
the default setting.
LK 7 LK 8
240 sec. No Limit
to access the Memory Block.
P
Setting
Title Class
Data
X = 0 6 0 s
D I S P L A Y
to access the Memory Block.
000 = No Limit
to go back on-line.
Default values:
Class 1 to Class 4 = 60 secs

Hold Recall Timer Selection (Non Exclusive Hold), 1-1-03

NEC Business Solutions Ltd
1-1-03
System Mode
1
Submode
1
Data No.
03
PC Programming
+ BM