Co/Pbx Busy Forward Station Assignment - NEC Xen IPK Programming Manual

Xen IPK
CO/PBX Busy Forward
Station Assignment
General Description
Use this Memory Block to specify up to two telephones to ring when a CO/PBX call terminates at
a busy station.
Display
Tel Port
No.
Data
(01~99)
No.
A0~C0
0 1 / 1 3 : F W D
T I M E
Programming Procedures
Go off-line.
1
2 Press LK4 + AC to access the Memory Block.
3 Use dial pad to change data.
Note: Use the following to enter data:
J
to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
R
to move to the next Tel Port No
Setting Data: Port No. 01
N
4 Press to write the data for the first transfer to station.
5 Enter second transfer to station.
N
Press to write the data.
6
P
7 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. If the Multiline Terminal where the forward is initially set (Forward 1) is busy, the call is forwarded to a second
specified station (Forward 2).
2. If all three stations are busy, the first station rings.
3. Telephone ports A0~C0 are ports 100~120.

4-13, CO/PBX Busy Forward Station Assignment

Forward Setting
Title No. 1/2 Data
1 =
D I S P L A Y
~
120
Programming Manual
4-13
System Mode
Submode
Data No.
PC Programming
Default Values
Not specified
DRAFT 3
Chapter 1 – 421
4
—
13
+ BTT