Isdn Extension-Based Caller Id Assignment - NEC Xen IPK Programming Manual

Xen IPK
ISDN Extension-based Caller
ID Assignment
General Description
This Memory Block provides the station DID Number (CPN, Calling Party Number) to the
Network when placing outgoing calls.
Display
Tel Port No. Data
(01~CO) No.
0 1 / 6 2 :
T I M E
Programming Procedures
Go off-line.
1
2 Press LK4 + FB to access the Memory Block.
3 Use the following to enter data:
J to move the cursor left.
L to move the cursor right.
K I
~ to enter numeric data.
– OR –
R
Press to go to the next TEL port number.
U
Press to clear data.
N
Press to write the data and display Memory Block , 4-01.
4
5 Program Memory Block , 4-01 or press
Related Programming
M.B. Number
3-53 ISDN Trunk Directory Number Assignment
3-91 Trunk Type Selection
4-47 ISDN Directory Number Selection
N
1. A maximum of 13 digits is allowed.
2. Hyphens/dashes are not allowed when entering the directory number.
3. This Memory Block supports only trunks assigned as DID in Memory Block , 3-91.
4. When using CO Line Mode, Memory Block , 3-53 is used to assign the directory number of ISDN.
5. Only numbers within the indial range are valid.

4-62, ISDN Extension-based Caller ID Assignment

Setting
Data
D I S P L A Y
P
to go back on-line.
Setting Data:
Telephone number to be programmed must
include area code, minus leading 0.
e.g.: 3 X X X X – X X X X
Memory Block Name
Programming Manual
4-62
System Mode
4
Submode
—
Data No.
62
PC Programming
+ BTT
DRAFT 3
Chapter 1 – 467