NEC Xen IPK Programming Manual page 447

Xen IPK
Settings
Page 7 (Ports 49~56)
LK 1 LK 2
49 50
LK 5 LK 6
53 54
Page 8 (Ports 57~64)
LK 1 LK 2
57 58
LK 5 LK 6
61 62
29 30
Programming Procedures
Go off-line.
1
2 Press LK4 + AI
3 Press the CO/PBX line key corresponding to each CO/PBX line.
The LED indication changes to indicate data each time a CO/PBX line key is
pressed.
CO/PBX
Line Key LED
Data Not Restricted
Note: Use the following to enter data:
J
to move the cursor left
L to move the cursor right
K I
~ to enter numeric data
U
to clear all data when cursor is at setting data position
R
to go to next Tel Port No.
4 After entering all data for all pages, Press
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. A restricted CO/PBX line allows the station user to answer an incoming call or access a held call, but does not
allow a user to originate a CO/PBX call.
2. If restricted is specified in this section, the data in Memory Blocks , 4-07 , Code Restriction Class Assignment
(Day Mode) and Memory Block , 4-08 , Code Restriction Class Assignment (Night Mode) is treated as invalid
even if specified.
3. Telephone ports A0~C0 are ports 100~120.
4-19, Trunk Outgoing Restriction
LK 3
51
LK 7
55
LK 3
59
LK 7
63
31
to access the Memory Block.
Off On
Restricted
N
LK 4
52
LK 8
56
There is no
default setting.
LK 4
60
LK 8
64
32
to write the data.
Programming Manual
Default Values
Off, Not Restricted.
DRAFT 3
Chapter 1 – 427